/testing/guestbin/swan-prep ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ipsec start Redirecting to: namespaces direct start via ipsec pluto ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# /testing/pluto/bin/wait-until-pluto-started ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# # These should load ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ipsec auto --add base 002 added IKEv1 connection "base" ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ipsec auto --add subnet4 002 added IKEv1 connection "subnet4" ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ipsec auto --add subnet6-good 002 added IKEv1 connection "subnet6-good" ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# # this one should fail to load ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02]# ipsec auto --add subnet6-bad 036 connection "subnet6-bad": failed to add connection: subnets must have the same address family ]0;root@swantest:/home/build/libreswan/testing/pluto/libipsecconf-02[root@west libipsecconf-02 36]# >>>>>>>>>>cutnonzeroexit>>>>>>>>>> exit status 36 west.sh 'ipsec auto --add subnet6-bad' <<<<<<<<<>>>>>>>>>cutnonzeroexit>>>>>>>>>> exit status 36 west.sh '' <<<<<<<<<>>>>>>>>>cut>>>>>>>>>> done <<<<<<<<<